Hi everyone,
After using the XY Plotter for a while I have run into a strange problem. It looks as if one of the stepper motor drivers is broken. When the board is plugged in, its power LED flashes at a steady rate. It will not light up steadily, nor will it react to any input from the software.
It also seems to prevent the other stepper motor driver (
https://www.oyostepper.es/category-16-b0-Controlador-de-motor-paso-a-paso.html) from initializing when plugged in. When unplugged, the other stepper driver becomes steady and operates normally. I have tried changing cables, plug ports, and connected stepper motors, but the problem seems to be with this stepper driver itself. Any suggestions?
Thanks!
